LINE HOSE/HOOD TEST EQUIPMENT You can be sure your line workers are safe and protected with Hanco’s line equipment test units.

 

 

 

 

  • The units are available in front-loading or top-loading models
  • Units provide a full high voltage electrical test  to hoses/hoods (as required by OSHA)
  • Hose test electrodes include an inside mandrel made of aluminum tubing and a fully hinged stainless steel outer cover with a felt-lined interior
  • Hood test electrodes are made of sponge material which completely fills all voids inside and outside of the hood or cover
  • The v-shaped groove holders hold the hoods in an upright position while keeping outside covers closed tightly on the hose
  • Test units are available for dedicated hose and hood testing. Combination test units are also available to test sticks, hoses and hoods

 

Standard Features:

 

  • Automatic digital fault detection, digital load sensing, digital leakage readout and power cycle
  • Standard 50KVAC power supply with optional 100KVDC power supply or a combination for both AC and DC testing
  • The high voltage test compartment contains mechanical grounding devices and safety interlock system with audible and visual warning signals covering all entries into the test cabinet for full operator safety and protection.
  • Microprocessor-controlled
  • PLC is self-diagnostic
  • All cabinets are made with formed 12-gauge steel, coated with primer and two coats of epoxy paint. Cabinets are rust and corrosion resistant
  • Automatic ozone depletion and dispersal system with programmed delays to insure complete removal of ozone from the testing cabinet
  • Digital voltmeter indicator
  • Leakage reading with a single set point for all test positions
  • Leakage digital milliamp monitor during the entire duration of the test
  • Voltmeters programmed to save peak voltage
  • Digital cycle timer
  • Insufficient air pressure warning indication
  • Control system has option for either manual or automatic cycle operation
  • Standard input voltage is 240V single phase with other inputs optional (specify when ordering)
  • Standard A.B. Panelview control system with full color display

 

 

Hanco also offers:

 

  • CAD-designed lab layouts with all equipment needed for a turnkey lab operation
  • Technical phone support
  • Complete field service support
  • On-site operator training and certification
  • On-site equipment calibration, inspection and certification (as required by ASTM and OSHA). All systems are checked as required for full compliance.

 

 

 

Request a quote today. (sales@hanco.com)

 

All of our cabinets are locally

manufactured by our partners

at Tri-Fab, Inc.

In compliance with:

 and IEC, IEEE and

OSHA 1910 Standards

 Authorized Hanco Distributors:

PROUDLY MADE IN

THE U.S.A.

HANCO INTERNATIONAL A Division of the Hannon Company 1605 Waynesburg Drive S.E. Canton, Ohio 44707 Phone: (330) 456-4728 Fax: (330) 456-3323 Email: sales@hanco.com support@hanco.com

© 2016 The Hannon Company. All Rights Reserved.

Site Last Updated: 10/24/2017